Shields 3/8" Low Perm Feeda1-15-250' 3680380

Shields Hose-Fuel Feed A1-15Lp 3/8X250 SHI-3680380

SAE J1527 Type A1-15
368 Series - ISO 7840. Low permeation fuel hose has a plastic barrier veneer with NBR outer layer tube to limit permeation. Polyester reinforced and complies with EPA and CARB low permeation requirements. Weather/UV resistant NBR/PVC cover.
WARNING - Special care should be taken when coupling Shields series 331, 337 and 368 EPA approved barrier fuel hoses. Always use a lubricant when inserting a fitting. Oil based or other lubricants designed for rubber or plastic assembly should be used. Silicone is not recommended as it may cause coupling retention issues. Over-sized fittings should not be used. The fitting should slide into the hose with minimum, but some, resistance. Using fittings with oversized barbs may result in damage to the barrier layer. If the fitting is too small it may not be possible to get a good seal. Sierra recommends the use of Oetiker stepless ear clamps or worm drive clamps to attach the fuel hose. Do not use wire ties or spring tension clamps. Over-tightening a worm drive clamp may result in damage to the inner layer and cause fuel to get in between the layers. This will cause the layers to separate and block the flow of fuel.

Fuel feed - gasoline up to 85% ethanol blended fuels / diesel / bio-diesel all blends

Meets USCG Type A1-15 requirements for pleasure boats

ISO 7840 Type A1

NMMA/CE type accepted

Temperature range: -20°F to 212°F

ID: 3/8"
OD: .68"
Length: 250'
Working Pressure: 100#

SKU: SHI-3680380
Category: Plumbing > Fuel Hose